BlackBoostedStang
Well-Known Member
Nice setup! I think i might copy you
Sponsored
I'll try to get a video of it this evening.Nice set up. Any video of it
Just completed the mod. Went to auto zone and picked everything up, out the door cheap!I'll try to get a video of it this evening.
I disconnected the hose completely from both ends, figured out how I wanted to arrange it, then connected it. It seemed to be a lot easier than trying to rotate the hose while it was still attached to the BPV. Definitely easier to do when the car has cooled down, though!I managed to squeeze the clip that connects the hose line to the BPV and rotate it a little so there isn't a big Kink in the line, but right now the filter is still touching the engine cover. It works just fine but my OCD is gong nuts lol :headbonk: I need to let the car cool down so I can comfortably remove it and make it proper
Do you really need to filter that bov? I have mine open for over 25k km.
That's correct for a mechanical BOV. However, the Mustang does not have a mechanical BOV. It is electronically controlled by the ECU. If you have an AccessPort, monitor the BOV status while you drive the car. You will notice the BOV is open at times even when you have a vacuum state instead of boost. That means it can be sucking air in through the open BOV. Hence a filter has been recommended to prevent unfiltered air from entering the open BOV.No. When it's closed, obviously nothing can get in, and when it's open, its forcing air out. It would be a miracle if some kind of debris made it in their. It's like trying to get dust down an "air duster" straw while its actively spraying pressurized air, ya not happening.
Sorry if this is a noob question, are u guys using the sock intakeThat's correct for a mechanical BOV. However, the Mustang does not have a mechanical BOV. It is electronically controlled by the ECU. If you have an AccessPort, monitor the BOV status while you drive the car. You will notice the BOV is open at times even when you have a vacuum state instead of boost. That means it can be sucking air in through the open BOV. Hence a filter has been recommended to prevent unfiltered air from entering the open BOV.
Sorry if this is a noob question, are u guys using the sock intake
Got cha, thanks the reply. . I'm returning my boomba bov adapter since it hisses and whistles on the highway. It will do that until u let off the gas. If/when I get a CAI I'll give this a try.. Torrie tried to help tune it down but it still did it :/You can vent BOV to atmosphere on a stock or aftermarket intake it doesn't matter. If you do it with the stock intake you have to find your own means to plug the stock intake port that will now be open. I think a lot of aftermarket intakes already come with a plug for you to have the option to run either.
As far as putting a filter on the BOV there's some dispute on that. My tuner said there's no reason for it. It's about as useful as putting a filter on your exhaust tips. Your BOV is opening to release pressure. Even when you're in vacuum. That's when it releasing the most anyway, right when you let off the throttle it opens to release pressure, and is doing so while in vacuum. Same on the highway it's releasing boost to save gas. If boost is going in the motor you need more fuel, so it does this for efficiency.
I just drove 500 miles highway and thought my valve was broken due to the amount it vented while under cruse control. Thanks for clarifying that my car isn't broken :headbonk:Same on the highway it's releasing boost to save gas. If boost is going in the motor you need more fuel, so it does this for efficiency.