Ahh gotcha, thanks for the heads up. I just ordered BMR springs, sways bars and end links so I'm trying to do my research ahead of time regarding ride height recal and mag ride reset. Just wondering if that's necessary or best practice?Personally, I think the magneride sensor was loose. I recall it being a PITA to get snug. I even called a buddy to complain about it and was a bit worried after the install that I'd get some code. Fired the car up and no issues. Per CJ Pony, they do recommend you disconnect the sensor which is the guide that I followed.
what did you use to show these codes?As of now, it's showing a error in each rear height sensor and a sensor supply fault. I cleared them to see if they all keep showing but now it only shows the sensor supply fault. So possibly a short somewhere in the harness, I'm assuming the fault means no power is going to the rear sensors. Can't find any pinches in the harness anywhere or anything unplugged. So gonna keep following the harness