jpjr501
Well-Known Member
- Joined
- Feb 29, 2024
- Threads
- 1
- Messages
- 143
- Reaction score
- 121
- Location
- Boca Raton, FL
- First Name
- Joe
- Vehicle(s)
- 2020 Mustang GT - Procharged
Yes, smashed the reds into oblivion. Went to all black and clamps on steedas recommendation.I gotcha. Have you tried the way Steeda recommends setting them up for drag racing (with a red over black and black over red) before going to all black? If so, did you notice a difference in performance at all?
![]()
![]()
Those urethane pucks are tiny vs the steeda units.
I think it's because they made them universal. They use the same bushings on the stock motor mounts, the BMR race motor mounts and another one they have. This way they can sell just one part number.Those urethane pucks are tiny vs the steeda units.
Oh okay. What size clamps did you go with and do you have any pics of them on the pucks? I would assume installing them on the pucks first is the way to go? ThanksYes, smashed the reds into oblivion. Went to all black and clamps on steedas recommendation.
No pics, just imagine worm clamps around the pucks. I did all 4. Clamps will tighten up any puck you currently have.Oh okay. What size clamps did you go with and do you have any pics of them on the pucks? I would assume installing them on the pucks first is the way to go? Thanks
I suppose my point was that a larger puck will last longer.I think it's because they made them universal. They use the same bushings on the stock motor mounts, the BMR race motor mounts and another one they have. This way they can sell just one part number.
They are 4 years old and not a mark on them. One of my pics shows a box full of them. I also have another box from the K-member with more of them.I suppose my point was that a larger puck will last longer.
Sounds like you are all set then!They are 4 years old and not a mark on them. One of my pics shows a box full of them. I also have another box from the K-member with more of them.