ATM Silicone Charge Pipes Production Pics

[JerseyDevil]

We are ready to take orders for our silicone charge pipes. As you can see by the pics below we took out a lot of unneeded volume, potential leak points and unneeded bends in our charge pipes. We designed these to be as straight as possible and also allow the ability to run either the stock diverter valve OR a plethora of aftermarket BOVS including Turbosmart, Synapse, HKS etc that can use a 1.5" hose adaptor. Also included in the kit are ultra high quality Murray dual bead Turbo Seal clamps. We currently have 10 sets getting manufactured and M6g pricing will be $300 plus shipping for the complete set including the billet factory DV adaptor and $275 plus shipping for the kit without the adaptor if you are going to purchase an aftermarket BOV! We will be posting a pre sale thread in the vendor section and will link to this thread!

[/IMG]

Sponsored

 

[ranger11x]

What about those of us with the turbosmart dual port?

 

[neodark]

Looks pretty good, have you performed any testing for temps/flow vs the OEM units? I never used silicone for the full pipe.

 

[JerseyDevil]

What about those of us with the turbosmart dual port?

The direct bolt on Turbosmart valve bolts to the billet adaptor just like the stock valve it replaces!

 

[JerseyDevil]

Looks pretty good, have you performed any testing for temps/flow vs the OEM units? I never used silicone for the full pipe.

We designed these to flow without excess bends or changes in diameter. As you can see by the pics they are a much simpler means to and from the end tanks. Silicone is also a very good insulator against heat!

 

[ronv95]

Looks pretty good, have you performed any testing for temps/flow vs the OEM units? I never used silicone for the full pipe.

Interested in this as well mainly compared against hard pipes. I'm thinking the silicon doesn't suffer from heat transfer like aluminum might and I like the fact it's just two connections and not 4 because of couplers with the aluminum pipes...

 

[JerseyDevil]

Interested in this as well mainly compared against hard pipes. I'm thinking the silicon doesn't suffer from heat transfer like aluminum might and I like the fact it's just two connections and not 4 because of couplers with the aluminum pipes...

The other advantage is you don't have pipe edges(where the tube and coupler come together) to disrupt the airflow!

 

[ronv95]

put that link up!

 

[BoostedRubyRed]

Will you also be offering a factory adapter to vent back into the intake like OEM?

 

[JerseyDevil]

Will you also be offering a factory adapter to vent back into the intake like OEM?

No these pipes are for a BOV conversion unless you decide to use a recirculating aftermarket valve...

 

[neodark]

We designed these to flow without excess bends or changes in diameter. As you can see by the pics they are a much simpler means to and from the end tanks. Silicone is also a very good insulator against heat!

Thanks for the answers... Any way you'd sell hot/cold side separately?

 

[93tcobra]

How long to get them, I have been waiting since oct for an ATM intercooler any update ?

 

[dausmus]

Might sell off my MAP pipes and get these to replace. Hmmm

 

[TheWildman]

I've got my eye on these.
Do they come only in black, or will there be other colors?

 

[bguerrero13]

Do all charge pipes run this much? Haven't really looked too much into inter cooler stuff.

Sponsored