TheShit
Well-Known Member
- Joined
- Jun 22, 2021
- Threads
- 44
- Messages
- 99
- Reaction score
- 83
- Location
- Memphis TN
- Vehicle(s)
- 2021 Mustang GT Manual
- Vehicle Showcase
- 1
- Thread starter
- #1
I have a vortech v3 kit from Beefcake
I was on the Dyno the other day and I keep getting code P0068 when it touches 6k RPM and it goes into limp mode.
On the street, I can run it to redline in 1st, 2nd or 3rd gear without any issues.
I tried to run it to redline in 4th on the street, and when you get close to 6k RPM, it throws P0068 and goes into limp mode.
Any ideas?
Before the blower install, I had it dynoed a few times and did not have this issue in 4th gear, it went to 8k RPM without any issues.
I was on the Dyno the other day and I keep getting code P0068 when it touches 6k RPM and it goes into limp mode.
On the street, I can run it to redline in 1st, 2nd or 3rd gear without any issues.
I tried to run it to redline in 4th on the street, and when you get close to 6k RPM, it throws P0068 and goes into limp mode.
Any ideas?
Before the blower install, I had it dynoed a few times and did not have this issue in 4th gear, it went to 8k RPM without any issues.
Sponsored