Search results

Did you ever figure this out, i think its the K061054. Could you confirm?

I ended up using an OEM ford line i had laying around that could flex around master cylinder. the gm hose wouldn’t allow me to use it in the orientation i needed. hope this helps.

I'm using the new one, no issues and idk if the previous owner replaced the plug ever... so i did it for peace of mind. no issues and i like the double o ring design more

best to just get rid of the cats, saves you the headache and thought in the back of your mind every time you make a pull.

Yup its pretty good and easy install.

what is wrong with that solution? I just ordered the parts for that filter and hoses and it came out to around $125. Didn't see too much of a difference between the two but if there are issues with that solution I may want to steer away. Thanks.

oh yea my bad, I read roush mufflers. It is really tame to be honest. I have the same setup and only under WOT is it loud but it has a really good note in my opinion. Also you may have some issues running the roush x pipe and the x pipe from speed engineering as the speed engineering ones are...

They're good, just get OEM header gaskets and check the welds before installation. Also it is gonna be crazy loud with the roush mufflers, I have heard the exact setup you have. Definitely the loudest N/A mustang I have heard.

bump

To change the blower oil, do you change through the vent plug on top so you wont have to take off the throttle body? I've heard people do that I just want to be extra sure before I drain my oil.

Not sure I'm still on the stock pulley E85, I'd say like 750WHP

I've seen Serna5.0 run 3.1 on his pacton 2200SL which I've heard is a very similar setup to the V3-Jt. I have the V3 as well but just for the health of the blower, I would just stick to the 3.3, I haven't seen anyone on a v3 on a 3.1 to be honest.

damn what camera?

that's interesting, did you swap the whole pumpkin or just gears?

The 3.55 gearing in my car tops out 6th gear at like 128 mph. I try to avoid 7th gear due to the weakness of it at higher power levels and a 3.15 would help take my 6th gear to a higher speed than the 3.55's. Im not sure where the 3.15's would top out 6th but I think its around 145mph which...

Awesome, so if i buy a forscan tool online, I change the gear ratio, and that calibrates everything? Would that mess with the tune on the car (Ex. reflash the car to stock tune?)

I've been boosted for some time and I have 3.55 gearing (2020 A10). I'm looking to swap to a 3.15 in the near future and I was wondering what the procedure is after the install. My tuner said no tune revision would be needed but what else needs to be done? Does someone need to go in and...

Any insight on the easiest way to change the oil on the V3-Jt supercharger? I know it is pretty straightforward however I'm just a little confused if I have to remove the intake and throttle body or if i can fill up the head unit through the vent hole which has a lot more access. Also does...