Search results

First build thread on the forum, short time forum lurker and question asker. Two years ago I bought my second car after saving for a few years. My first was a 1995 Honda Accord EX Coupe I bought at 14 (she sat pampered in my garage until I was old enough to drive her). She developed transmission...

Do you all recommend I go for the "RaceLouvers" RT louvers? (highest level made for 2015-2017, RX is 2018+ apparently)

Is it fine for dailying as well?

Which radiator do yall suggest? GTPP or a Koyorad or? Want to tackle mechanical cooling before adding louvers

Bump. Price reduction!

Wishing you all the luck! Please make a thread with lots of pictures!!!

Anything over 7500 rpm is impressive to me...I don't even think my cyclone can reach 7510, let alone 8k. Maybe I am just doing it wrong (or I am misremembering my shifting/tune), but there is so little documentation on my engine (in terms of true performance ideas).

Interesting, I have yet to scrape anywhere, and I have a steep sidewalk gutter style driveway.

Thank you, I do too ;) I daily drive this car. Need I say more? Progressives are godly, linear for track only.

Note: I am a V6. From factory 30lbs lighter than base ecoboost. My car currently sits somewhere below 3500lbs with little fuel and no driver.

My car squats front at a slight rake. 1.74” drop front and back just about. Love the look on 19x11s (LMR SVE GT7s with Michelin 4PS 295/35/ZR19 SQUARE). Steeda Non-Adjust Shocks/Struts, Steeda Sport Progressive Lowering Springs, cut jounce bumpers, camber plates (track camber setup: -2.9 front...

Good info…I will focus on coyote or procharger then lol.

Do it! Wish I could be there to help and learn for when I blow my 6 up one day 🫣😉

Ha, street class my behind, that's a monster

Added something that the V6 S550 should have had as an option…the PP1 option.

I would want the fenders if you had, but same deal as sstone, probably expensive to ship to Cali.

Husky 3-ton low profile jack with 4 craftsman 3-ton jack-stands. Love them. I'm lowered 1.75".

Check. Next?

***Manuel T. disliked your post***

Definitely going to try something like this